Identifying The Parts (Remote Control); Battery Installation - Teac TU-1000 Mode D'emploi

Remote control
a
b
c
d
e
f
a
MUTE
b
TUNING j (previous tuning button)
Hold down 2 or 3 seconds for auto selection of the previous channel.
c
TUNING k (next tuning button)
Hold down 2 or 3 seconds for auto selection of the next channel.
d
PRESET j (previous station button)
e
PRESET k (next station button)
f
0-9 (number buttons)
g
RDS
Hold down 2 or 3 seconds for brightness adjustment.
h
MODE
i
FREQ (frequency direct input)
8

Identifying the Parts (remote control)

g
h
i
j
k
l
j
MEMORY
k
BAND (band switch button)
l
TUNER (tuner switch button)
Note before using the remote control
Press the TUNER button to switch to the TUNER mode before
o
operating the unit by using the remote control.
The effective range of the remote control is no greater than 10m
o
and an angle no greater than 30 degrees.
Buttons that are not listed or mentioned in the remote control
o
diagram are not used for this unit. It is normal that there will be no
response when you press them.

Battery installation

1
Open the cover of the remote control unit.
2
Insert two AAA batteries. Make sure that the batteries are
inserted with their positive ¥ and negative ^ poles
positioned correctly.
3
Close the cover.