Retracting The Support Arms; Maintenance And Care - minnid e.hit 120 Mode D'emploi

E
N
5

Retracting the support arms

Ø Remove all accessories from the e.hit
support arm.
Ø Press and hold the operating button in the
motorhome rear garage to extend the
system.
Ø Continue to hold the button down
throughout the entire manoeuvre.
Ø Pay attention to the beeps:
•
Short beep – system is moving
•
Double beep – system has finished
retracting
Ø Check that the lower housing cover has fully
retracted.
1.240.060BA_20200302
6

Maintenance and care

Ø Make sure that the support arms and
particularly the connector for the e.base
power supply are free of dirt deposits.
______________________________________
ATTENTION!
Risk of damage due to improper cleaning!
High-pressure cleaners, scouring agents or
aggressive cleaning agents can damage the
carrier rack.
Ø Clean the carrier rack using water and car
shampoo.
___________________________________
The carrier rack must be maintained as
follows:
Ø Clean the carrier rack on a regular basis.
Ø Remove salt and dirt after use in winter.
Ø At regular intervals, spray the connector for
the e.base power supply with contact spray.
Do this after cleaning it each time, or at
least every two months.
19