System Requirements; Installing The Device - König Electronic CMP-USBSER10 & 20 Mode D'emploi

Introduction:
The USB 2.0 serial adapter is a smart and convenient accessory for connecting RS-232 serial devices to your USB-
equipped Windows host computer. It provides a bridge connection with a standard DB 9-pin male serial port connector at
one end and a standard Type-A USB plug connector at the other end. You simply connect the serial device to the serial
port of the cable and plug the USB connector into your PC USB port. It offers a simple and easy way of adding serial
connections to your PC without having to go through inserting a serial card and traditional port configuration.
Features:
• Smart USB to R-232 (DB 9-pin male serial port) interface
• Supports various serial devices, modes, PDAs, cellular phones, digital cameras, card readers and more
• Easy plug and play installation
• Compatible with USB Specification V1.1 & V2.0 (Full-Speed)
• No IRQ resource required
• Supports remote wake-up and power management
• Bus powered, no separate power supply or battery required
• Supports Windows ME/2000/XP/Server 2003 and Vista 32/64 bit

System Requirements:

®
• Windows 98, Windows
• AMD or Intel Pentium 133MHz or better based computer
• USB 2.0 or lower port

Installing the device:

This section will guide you thru the installation procedure of the USB 2.0 serial adapter in
®
Windows XP, 2000, ME, 98 operating systems.
Note: Please take notice of the installation order. First, plug in the USB to serial adapter and then run the Install
Shield wizard
The following steps will show how to install the device under Windows
the same for other Windows
1. Connect the USB 2.0 serial adapter to the USB port on your PC, the computer will find the new hardware
automatically.
® ®
ME, Windows 2000, or Windows
®
operating systems.
ENGLISH
®
XP operating system
®
XP. Basically, the procedures are also somewhat
2