Basic Operation; Screen Display On/Off; Adjusting The Volume; Switching The Source - Alpine PKG-M780 Mode D'emploi

Basic Operation

DISP

Screen Display ON/OFF

1
Press the POWER button.
2
To turn off the POWER, press the POWER
button again.
• If properly connected, the monitors main
POWER will turn off when the vehicle's
ignition switch is off.
• After turning the system off, a slight ghost of
the image will remain temporarily. This is an
effect peculiar to LCD technology and is
normal.
• Under cold temperature conditions, the
screen may lose contrast temporarily. After a
short warm-up period, it will return to
normal.

Adjusting the Volume

1
Adjust the volume level by pressing the
button.

Switching the Source

Press the SELECT button.
Each press of the button will cycle through the modes as
follows:
1
POWER
SELECT
2

Switching the display mode

1
or
If AUX3 SELECTION S/W of Black Box is
• "IN" position
AUX1 AUX2
• "OUT" position
AUX1 AUX1 AUX2 AUX2
If current screen mode is AUX3, and AUX3
SELECTION S/W is switched to "OUT" then
screen mode will be changed AUX1.
Press the DISP button.
Each press of the button will cycle through the
modes as follows.
WIDE NORMAL
Normal images are
expanded uniformly in
the horizontal direction
and are displayed over
the entire screen.
WIDE
Normal image (4:3)
NORMAL
Normal images are
expanded in the
horizontal direction and
are displayed over the
entire screen. The
ZOOM
expansion ratio
increases towards the
right and left edges of
the screen.
AUX3
ZOOM
- E N