Lindy BTS-360 Manuel Utilisateur page 3

User Manual
Pairing with NFC devices
1. Enable NFC on your audio device
2. Press and briefly hold the Power Button on the
BTS-360 to switch it on
3. Touch the NFC area of your device against the NFC
Tag of the BTS-360
Pairing with Bluetooth devices
1. Press and briefly hold the Power Button on the
BTS-360 to switch it on
2. Press and hold the Pairing Key, the BTS-360 will
then bleep, continue to hold the Key down until the
blue light around the Pairing Key begins to blink
3. Enable Bluetooth on your audio device
4. On your audio device now begin a search for new
Bluetooth devices
5. From the list of available devices select LINDY
BTS-360
Once you have paired your device and the BTS-360 they should automatically connect in the future;
assuming Bluetooth is enabled on your audio device and you are within range of the BTS-360.
If after being switched on the BTS-360 does not make a Bluetooth connection after 15 minutes it will
power down to conserve battery. To manually power the speaker down press and hold the Power Button
for 5 seconds until the LED turns off.
When your audio device is connected to the BTS-360 you can control playback of audio and the output
volume directly from your audio device.
Battery/Charging Hazard
1. Only charge the battery in accordance with this user manual
2. Do not dispose of your BTS-360 in fire, as the battery could explode causing serious injury or
death
3. Do not attempt to disassemble the BTS-30 or force open the built-in battery as this may result in
an electric shock
4. Do not charge the BTS-360 in damp areas or in extremely high/low temperatures as this may
result in electric shock
5. Do not clean the BTS-360 whilst it is on charge or connected to the electrical power supply.
Always unplug the BTS-360 before cleaning
NFC Tag
Location
English
Pairing Key