Pack Contents; Cleaning, Care & Maintenance - NISBETS ESSENTIALS Fly Killer Mode D'emploi

• The appliance is not to be
used in locations where
flammable vapour or
explosive dust is likely to
exist.
• Do not use in barns, stables
and similar locations.
• Nisbets Essentials
recommend that this
product is connected to
a circuit protected by an
appropriate RCD (Residual
Current Device).
Introduction
Please take a few moments to carefully read through
this manual. Correct maintenance and operation
of this machine will provide the best possible
performance from your Nisbets Essentials product.

Pack Contents

The following is included:
• Fly Killer
• Instruction manual
• Hanging chain
Nisbets Essentials prides itself on quality and service,
ensuring that at the time of packaging the contents
are supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your Nisbets Essentials dealer
immediately.
Installation
Note: Ensure the mounting substrate and the
fixings used can support the weight of the
appliance. If in doubt seek professional advice or
assistance.
1. Remove all packaging and protective film from
the Fly Killer.
FD499_ML_A5_v1_20201217.indb 3 FD499_ML_A5_v1_20201217.indb 3
2. For best results, locate the Fly Killer in the
darkest part of the room, but at least 1 metre
away from food preparation areas.
Note: Close proximity to other
light sources such as sky lights
and windows will reduce the
effectiveness of the Fly Killer.
3. Connect the appliance to mains power.
Operation
WARNING: Under no circumstances
should hands be placed anywhere
near the high voltage grid when the
appliance is operational.
The fly killer works by luring insects on to an
electrified metal grid using ultra-violet light. It uses
no chemicals and is pollution free. To use the Fly
Killer:
1. Press the switch to the ON (I) position. Ensure it
is set to OFF (O) before plugging into mains.
2. The light will come on and the grid will become
electrically charged.
Cleaning, Care &
Maintenance
Always switch off the power and
disconnect the appliance from the
power supply before cleaning.
• Clean the collection tray regularly with warm
soapy water.
• DO NOT immerse the appliance in water. Wipe
the safety guard and external casing with a damp
cloth.
• Change the bulbs every 9 months.
Changing the Bulb
WARNING: Always turn Off the
appliance and disconnect from the
power supply before changing the
bulb.
UK
3
2020/12/17 10:29 2020/12/17 10:29