Safety Notes; Applications; Setting Into Operation; Operation With The Stand - Leuchtkraft PARL-45SET Mode D'emploi

2

Safety Notes

The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit uses dangerous mains volt-
age. Leave servicing to skilled per-
sonnel. Inexpert handling or modifi-
cation may result in electric shock.
Please observe the following items in any case:
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity and heat (admissible ambient tempera-
ture range: 0 – 40 °C).
G
Do not place any vessel with liquid on the unit,
e. g. a drinking glass.
G
Do not operate the unit and immediately discon-
nect the mains plug unit from the socket
1. if the unit or the mains cable is visibly dam-
aged,
2. if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by skilled
personnel.
G
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is not
correctly connected or operated, or if it is not
repaired in an expert way.
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment.
3

Applications

The spotlight set PARL-45SET consists of four flat
LED spotlights mounted to a controller. It can be
.
used to create effect illumination, e. g. on stage, in
discotheques or in ballrooms. Each spotlight fea-
tures three super-bright RGB LEDs as a light
source. The LEDs can emit light in the three pri-
mary colours (red, green and blue) or coloured light
from additive colour mixing.
A set can be operated on its own, with the foot
remote controller supplied or by means of the DMX
controller (3 or 15 DMX control channels). In addi-
tion, it is possible to interconnect multiple spotlight
sets (master / slave mode) and to control all of them
by means of a foot remote controller. Various light
programs are available. The integrated microphone
provides effects in sync with the music.
A stand and two transport bags for mobile oper-
ation as well as two mounting brackets for fixed
installation are supplied with the unit.
4

Setting into Operation

4.1 Operation with the stand

1) Place the stand on a horizontal, solid ground.
For a safe position, spread the legs of the stand
as far as possible and fix them with the
setscrew.
2) Place the controller with the spotlights onto the
stand tube (a) and fix it with one of the screws
supplied (b) [fig. 3].
3) To adjust the operating height desired: Pull out
the telescopic tube and push the safety pin
through the two holes for the height desired,
then slide back the tube until the safety pin rests
on the outer tube. Use the setscrew to addition-
ally fix the telescopic tube.

IMPORTANT!

G
Make sure that the stand is stable. Pull out the
telescopic tube only to such an extent that the
stand cannot fall over.
G
Prior to operation, check all setscrews and, if
necessary, tighten them.
G
Lay the connection cables in such a way that
nobody will trip over them and may overturn the
stand.
11