Nikken PiMag Aqua Pour Deluxe Manuel D'utilisation page 3

AQUA POUR DELUXE TANK UNIT SPECIFICATIONS
Dimensions
Diameter: 9.8 in/24.9 cm
Height: 21 in/53.3 cm
Weight
11 lb/5 kg
Water tank capacity
3.9 gallons/15 liters
Magnet strength
1,200 gauss
Flow rate
With microsponge: 4 minutes per liter (40 minutes for full tank)
With ceramic filter: 30 minutes per liter (5 hours for full tank)
Component life
Filter cartridge: 6 months or 2,000 liters, whichever comes first*
Mineral stones: 1 year or 4,000 liters*
Ceramic filter: 2 years or 8,000 liters*
Microsponge: 5 years or 20,000 liters*
*Component life may vary, depending on water quality
Nikken EPA Establishment No.: 75805-CA-001
Aqua Pour meets NSF/ANSI 42 standards for chlorine reduction as verified and substantiated by
test data.
TANK UNIT TROUBLESHOOTING
Problem: Water does not flow into supply tank.
Cause: Air trapped in microsponge filter.
Solution: When water fill tank is full, press on microsponge, or pull upward on edge of microsponge, to
release air bubbles. Make sure that microsponge is correctly seated afterward.
Problem: Microsponge filter is discolored.
Cause: Microsponge filter is dirty.
Solution: Clean or replace microsponge filter.
Problem: Water has a disagreeable taste or odor.
Cause: Poor water quality or filters need replacing.
Solutions: (1) Check quality of water used in system. (2) Clean or replace microsponge filter.
(3) Replace filter cartridge.
Visit the Aqua Pour Web site at www.e-nikken.com/aqua_pour for more information and FAQs.
-3-