Table des Matières
Publicité
FCC Compliance Statement
This equipment has been tested and found to comply within
the limits of a Class B digital device pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate
radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio
or television reception (which can be determined by turning
the equipment on and off), the user is encouraged to try
to correct the interference by using one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
the receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
Caution: Changes or modifications not expressly approved
by the party responsible for compliance could void the
user's (or your) authority to operate the equipment. Only
peripherals (digital input/output devices, terminals, printers,
etc.) certified to comply with the Class B limits may be
attached to this monitor. Operation with non-certified
peripherals is likely to result in interference to radio and TV
reception. Only shielded signal cables may be used with
this System.
NOTICE
The regulations are applied only to the products with the
ID LABEL indicating specific requirements.
Canadian DOC Notice
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
Cet appareil numéique de la classe B respecte toutes
les exigences du Rèlement sur le matéiel brouilleur du
Canada.
NOTICE
The regulations are applied only to the products with the
ID LABEL indicating specific requirements.
CE Conformity Notice
Products with the "CE" Marking comply with the EMC
Directive(2004/108/EC) and LOW VOLTAGE Directive
(2006/95/EC) issued by the Commission of the European
Community.
Compiance with these directives implies conformity to the
following European Norms :
EN 55022
; Radio Frequency Interference
EN 55024
; Electromagnetic Immunity
EN 61000-3-2
; Power Line Harmonics
EN 61000-3-3
; Voltage Fluctuations
EN 60950-1
; Product Safety
NOTICE
The regulations are applied only to the products with the
ID LABEL indicating specific requirements.
NOM MARK
(Mexico only)
Green Mark
(for Japan)
(for Europe)
Publicité
Table des Matières
