MediaShop PANCA Mode D'emploi page 13

RETRIEVING RECORDINGS
1. Remove the microSD card from the Panta® Pocket Cam by gently pushing the
microSD card inward to release, then gently pulling the card out of the slot. Insert
the microSD card into an SD card adapter (not provided) (Figure I). Once the
microSD card is inserted into the adapter, plug the adapter into the SD card port of
your computer/laptop.
NOTE: The SD card port can be located on either the left or right side of your
computer/laptop.
2. If you do NOT have a microSD card adapter, or your computer/laptop does NOT have
an SD card port, simply use the provided USB cable to connect the Panta® Pocket
Cam to your computer/laptop. Plug the Micro-USB connector end of the USB cable
into the camera (Figure K). Once the Micro-USB cable is plugged into the camera,
plug the other end of the USB cable into the USB port of your computer/laptop
(Figure L).
3. Access the footage by going to the drive associated with the Panta® Pocket Cam.
Go to the DCIM folder to view the files. You can view, save, or delete recorded videos
& photos there.
USING CAMERA WALL MOUNT, TABLE STAND & CAMERA CLIP
Assembling the table stand
1. Hold the wall mount in one hand and the camera clip in the other.
2. Gently press the camera camera clip clamp together to open (Figure M1).
3. Insert the grooved base of the wall mount into the opening of the camera clip, and
allow the grooves to align (Figure M2).
4. Now the wall mount is fully assembled and is ready to be used as a table stand.
Using the camera clip
1. Place the camera clip on the back of the unit (Figure N). Gently press the camera
camera clip down until the clips enter the Panta® Pocket Cam mounting grooves,
located on the left and right sides of the camera.
NOTE: A faint click will indicate correct mounting. Make sure that the on/off switch
is positioned to the side when the unit is in use. To remove the camera clip, gently
slide the clips either up or down out of the camera mounting grooves.
Using the wall mount
1. To mount the Panta® Pocket Cam using the mounting tape provided, first peel off a
single side of the mounting tape and place on the back of the wall mount (Figure O).
M18205_PantaPocketCam_Manual_A5_20190201_CP.indd 13
13
01.02.19 08:47