How To Use The Appliance - Linea Domo DO7341H Mode D'emploi

DO7341H
• Make sure that there is an empty space of at least 20 cm between the ceiling and
the appliance and an empty space of at least 20 cm between the appliance and any
side walls, to ensure a decent air flow. Also take the above mentioned instructions
into account what the placement in bathrooms is concerned.
• Attach the base of the wall mount to the wall with the supplied plugs and screws.
Attach the wall mount to the base, by inserting the screw knob in the center of the
appliance and base. Turn to thoroughly fasten. Click the appliance onto the wall
mount, as shown in this picture:
• To remove the appliance from the wall mount, press
the small lever at the bottom of the wall mount. You
can now remove the appliance from the wall mount.
Now you can also remove the wall mount if you
should want to.

HOW TO USE THE APPLIANCE

• Connect the plug to the power outlet.
• Switch on the appliance by using the on/off switch at the left side of the
appliance. You will hear 2 beep sounds.
• Turn on the appliance by pressing the standby button. Press the standby button
again to put the appliance in standby. Careful: after you have pressed the button,
the appliance will heat for another 10 seconds before going into standby mode.
• You can choose between 2 power settings: Low (1300 W) and High (2000 W).
Select the desired power by pressing the power selection button. The selected
power will be displayed left from the button.
• Press the temperature button to start setting the temperature. You can now press
the + and - buttons to set the desired temperature with the precision of 1°C. You
can set the temperature from 5°C upto 35°C. Once you have selected the desired
temperature, press the temperature button again to confirm. The appliance will
now heat up until the set temperature is reached.
• You can also set the room temperature as your desired temperature. Press the
temperature button and wait for 5 seconds. The appliance will automatically select
the room temperature. Confirm by pressing the temperature button.
36