T.O.M TRD250 Manuel D'utilisation page 23

CarBOn BrUsH rEPLaCEMEnT (By a COMPETEnT PErsOn)
This planer thicknesser has circuit breaking carbon brushes; turn the machine over and unscrew the base. Remove the cover of the carbon
brush holder and change the brushes. Close the cover and fasten the base.
CHiP rEMOVaL
The machine should be connected to a chip extractor or an extraction device for proper operation and a long life.
OVErLOaD PrOTECTiOn
If the thermal protection of the motor trips, this means that the motor is overloaded. Locate the reason for the overload and the fault and
eliminate it (overheating, jamming, excess pressure on the workpiece etc.) In the event of overheating the motor will switch off automatically.
Let it cool by disconnecting the machine from the power source machine from the power source.
rECOMManDaTiOns!
do not feed the workpiece too fast, as the machine must run at full speed. Move the workpiece gradually so as to not apply force on the
machine.
If the machine slows down or stops, it means it is under excess load.
Stop immediately and let the motor cool by letting the machine run empty for a few moments.
The wood is stopped by the outfeed table: incorrect adjustment of the cutters or the outfeed table.
A heel forms at the end of the workpiece: the piece is not straight after thicknessing or the cutters are incorrectly adjusted or the workpiece
is incorrectly presented or received on the machine.
23