Safety Tips; Product Description; Pack Contents - Buffalo CD474 Manuel D'instructions

UK

Safety Tips

•
Position on a flat, stable surface
•
A service agent/qualified technician should carry out installation and any repairs if required. Do not remove and components or
service panels on this product
•
Consult Local and National standards to comply with the following:
•
Health and safety at work legislation
•
BS EN Codes of practice
•
Fire Precautions
•
IEE wiring regulations
•
Building regulations
•
DO NOT use jet/pressure washers to clean the appliance
•
DO NOT use the appliance outside
•
DO NOT allow oil or fat to come into contact with the plastic components. Clean immediately if contact occurs
•
DO NOT store products on top of the appliance
•
Always carry, store and handle the appliance in a vertical position and move by holding the base of the appliance
•
Do not carry when hot
•
Always switch off and disconnect the power supply to the unit before cleaning
•
Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities
•
If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified technician in order to avoid
a hazard
•
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.

Product Description

CD474 - Buffalo Bistro Contact Grill, Single Ribbed plates
DM902 - Buffalo Bistro Contact Grill, Double Ribbed plates
DM903 - Buffalo Bistro Contact Grill, Large Ribbed plates
GJ454 - Buffalo Bistro Contact Grill, Single Flat plates
GJ455 - Buffalo Bistro Contact Grill, Large Flat plates
GJ456 - Buffalo Bistro Contact Grill, Double Flat plates

Pack Contents

Buffalo Bistro Contact Grill
Scraper
Allen Key
Should you find any damage as a result of transit, please contact your Buffalo dealer immediately.
Installation
Remove your Buffalo Bistro Contact Grill from its packaging and be certain that all protective plastics and residues are thoroughly cleaned
from its surface.
Locate on a firm level surface.
Buffalo recommended that you allow no less than 100mm ventilated gap around the perimeter of this unit. Ensure that the stainless steel
waste tray is correctly positioned.
Connect to the electricity supply using the plug, the Grill is now ready to turn on and operate.
Preparing the cooking surface - make sure the cooking surface is clean, turn the unit on and apply a
generous amount of oil to the plates. Using the thermostat control, set the Grill to 110˚C, when the Grill has reached temperature, switch off
and carefully wipe any excess oil from the plates.