Publicité
HAVE THE POWER TOOL REPAIRED BY QUALIFIED
PEOPLE. ANY POWER TOOL THAT CANNOT BE
CONTROLLED WITH THE SWITCH IS DANGEROUS
AND MUST BE REPAIRED BY A QUALIFIED PERSON.
DISCONNECT THE POWER TOOL FROM THE POWER
SOURCE BEFORE ANY INTERVENTION. DISCONNECT
THE PLUG FROM THE POWER SOURCE AND/OR THE
BATTERY PACK BEFORE MAKING ANY ADJUSTMENT,
CHANGING ACCESSORIES, STORING THE POWER
TOOL, AND MAINTAINING THE POWER TOOL.
STORE POWER TOOLS IN A SAFE PLACE. STORE
IDLE POWER TOOLS IN A DRY AND A CLEAN PLACE,
OUT OF THE REACH OF CHILDREN.
MAINTAIN PREVENTIVELY THE POWER TOOL.
MAIN SAFETY INSTRUCTIONS FOR CIRCULAR SAW
CHECK WHETHER THE LOWER GUARD WHICH
FUNCTION CONSISTS OF COVERING THE BLADE IS
WELL FIXED BEFORE EACH OPERATION. THE LOWER
GUARD MUST BE ABLE TO BE DEPLACED AROUND ITS
AXIS
WITHOUT
BEEN
OBSTRUCTED
OBSTACLE. THE LOWER GUARD SHOULD NOT BE IN
CONTACT WITH THE SAW BLADE. THE LOWER GUARD
SHOULD BE RAISED BY THE RETRACTING LEVEL OR
BY THE LOWER GUARD LIFT LEVEL ONLY.
ALWAYS OPERATE YOUR CIRCULAR SAW WITH
YOUR TWO HANDS. OPERATE YOUR SAW WITH YOUR
TWO HANDS TO RESIST ANY BINDING AND KICKBACK
MOVEMENTS PROVOKED BY ANY REVERSE BOUND
OF THE SAW BLADE FACING AN OBSTACLE. THE
KICKBACK IS A DANGEROUS REVERSE MOVEMENT
OF THE CIRCULAR SAW THAT CAN HIT THE SAW
OPERATOR WHILE CUTTING EVERYTHING ON THE
SAW TRAJECTORY.
DO NOT ALIGN YOURSELF ALONG WITH THE SAW
BLADE DIRECTION. POSITION YOUR BODY AND ARMS
FORWARD BY MAINTAINING A FIRM GRIP WITH BOTH
HANDS ON THE SAW TO RESIST ANY KICKBACK
Ref.: 647062
-
INSPECT REGULARLY THE MOUNTING PARTS;
CHECK IF ALL THE LOOSE SCREWS ARE
PROPERLY TIGHTENED.
-
REGREASE THE POWER TOOL WITH GEARS
WITH SPECIAL LUBRICANT AT EVERY BRUSH
CHANGE.
-
AFTER REGULAR EXAMINATION OF THE STATE
OF THE BRUSHES AND COMMUTATOR, SEE
WHETHER
CHANGED.
-
CLEAN YOUR POWER TOOLS BODY USING A
CLEANING CLOTH LIGHTLY WET WITH A MIXED
SOLUTION OF WATER AND SOAP.
FORCES. IT IS RECOMMENDED THAT ONE OF YOUR
HANDS GRIP THE AUXILIARY HANDLE OF YOUR
CIRCULAR
SAW
CONTROL OF YOUR TOOL IN OPERATION.
BY
ANY
WHEN
THE
"ON/OFF" TRIGGER TO STOP THE SAW ENGINE. WAIT
UNTIL
THE
WITHDRAWING
MATERIAL.
DO NOT HOLD THE WORK PIECE BETWEEN YOUR
HANDS OR ACROSS YOUR LEGS. THE WORK PIECE
MUST BE FIXED ON A STABLE SUPPORT TO AVOID
ANY MOVEMENT CAUSED BY THE WORK PIECE TO
MAKE THE CIRCULAR SAW UNCONTROLLABLE.
TIGHTEN THE BLADE DEPTH AND THE BEVEL
AJUSTING KNOBS BEFORE MAKING CUT. IF IT
HAPPENS THAT THE ADJUSTMENT KNOBS SHIFT
DURING THE CUT, IT MAY LEAD THE SAW TO
KICKBACK.
9
THESE
PARTS
NEED
FIRMLY
TO
ENSURE
BLADE
IS
JAMED,
RELEASE
BLADE
IS
MOTIONLESS
THE
SAW
BLADE
FROM
TO
BE
BETTER
THE
BEFORE
THE
Publicité
