Teac UD-505 Mode D'emploi page 28

Playing back music on a computer (continued)
Playing back audio files from a computer
1
Connect this unit to the computer using a USB
cable.
o Use a cable with a connector that matches that of this unit.
2
Turn the computer on.
o Confirm that the operating system has started properly.
3
Shift the POWER switch to its ON position to
turn the unit on.
4
Turn the INPUT knob to select USB.
28
USB cable
5
Start playback of an audio file on the computer.
By maximizing the output volume from the computer and
adjusting the volume output from the stereo amplifier, better
sound quality can be achieved.
Minimize the stereo amplifier volume before beginning play-
back. Then, gradually increase it.
When using headphones connected to this unit, turn the
VOLUME knob counterclockwise to minimize the volume before
putting them on. Then, gradually increase it.
o The computer and this unit cannot control each other.
o Do not do any of the following when playing back an audio file
via USB. Doing so could cause the computer to malfunction.
Always quit the audio playback software before doing any of the
following.
o Unplugging the USB cable
o Turning the unit off or putting it into standby mode
o Changing the current input selection
o When playing back an audio file via USB, computer operation
sounds will also be output. If you do not want these sounds to
be output, make appropriate settings on the computer to turn
them off.
o If you connect this unit with the computer or change its input to
USB after starting the audio playback software, audio files might
not play back correctly. If this should occur, restart the audio
playback software or restart the computer.