Yamaha YIT-W10 Mode D'emploi page 6

LED
Off An iPod or iPhone is not
connected, or has stopped
playing. However, lights up
for 30 seconds or 2 minutes
(depends on the iPod/iPhone)
after connecting or stopping
playback.
Flashes green Connection in progress,
continuously please wait.
Flashes green Adjusting the volume level.
once
Lights up A connection is established.
green You are ready to start
playback of iPod on another
Yamaha product.
Lights up Flashes red for 2 seconds: An
green and unsupported iPhone or iPod is
flashes red connected.
Keeps flashing red:
Connection failed.
Flashes red The battery of the iPod or
(regardless of iPhone is low.
green status)
4 Adjust the angle of your iPod or iPhone
so that it is aligned parallel to PDX-50TX.
5 To charge the iPod or iPhone, place it on
PDX-50BC.
4
En
Status
■ Group selection switch
Use this switch to set the group ID. To establish a
wireless connection (AirWired) with another
Yamaha product, set both the products to the same
group.
Group selection switch
y
• PDX-50TX supports "1" (A1), "2" (A2), and "3"
(A3) on some Yamaha products that support
"AirWired".
■ Disconnecting the iPod or
iPhone
To disconnect the iPod or iPhone from PDX-50TX
(transmitter), pull the iPod or iPhone upward.
y
• Disconnection may be difficult under low
temperature. In this case, do not disconnect the
iPod or iPhone by force; loosen off the tab on the
back of PDX-50TX to make the disconnection
easier.
Match the group
selection switch with
the group ID to set.