Publicité
Les langues disponibles
Les langues disponibles
QUARTZ METRONOME
QT-2
QT-2
OWNER'S MANUAL
Thank you for purchasing the YAMAHA QT-2 Quartz Metronome.
Please read this manual thoroughly and keep it in a safe place for future reference.
I PRECAUTIONS
N To prevent damage, do not use the metronome in the following locations:
• places where the unit will be in direct sunlight;
• places subject to temperature and humidity extremes;
• places that are sandy or dusty.
N Power is supplied to the QT-2 by a 6F22 (006P) 9V dry cell battery and a CR2025
lithium battery. The 9V battery powers the metronome/note functions, and the lithium
battery powers the clock.
N Switch the power off when the metronome/note function is not used.
N If the QT-2 will not be used for a long amount of time, disconnect the 9V battery from
the unit. Doing so will prevent battery leakage.
N Do not subject the metronome to strong physical shock or vibration. Do not use
excessive force on any of the controls.
N Never use solvents such as benzene or thinner to clean the metronome. Wipe clean
with a soft, dry cloth.
N After reading the owner's manual, keep it in a safe place for future reference.
Never dispose of used batteries by burning them.
Also make sure to keep batteries away from children.
I BATTERY REPLACEMENT
A lithium battery for the clock(CR2025), and a 9V dry cell battery for the metronome/note
function 6F22 (006P) are supplied with the QT-2.
When the battery weakens, the tempo lamps w grow dim and overall volume decreases.
Replace the battery with a new one (6F22 (006P) 9V) as soon as possible.
Also, when the clock display fades, replace the lithium battery with a new one (CR2025)
as soon as possible.
N Replacement Procedure
6F22 (006P) 9V Battery: Remove the old battery from the battery connector, and
replace it with a new one. Make sure the +/- polarities on the connector, and the
battery, are properly aligned before connecting the battery.
Lithium Battery (CR2025): Remove the screw and the battery holder. Use the end of
a pair of narrow tweezers to remove the battery. Insert the new battery with its "+" pole
facing up. Re-attach the battery holder with the screw.
* Always replace batteries with the QT-2's power turned off.
Replacing the lithium battery with the power turned on, may result in loss of the
metronome/note's display and tone.
Screw
Battery connector
Battery cover
Bij dit produkt zijn batterijen geleverd.
Wanneer deze leeg zijn, moet u ze niet
weggooien maar inleveren als KCA.
I SPECIFICATIONS
Tempo
: 30 – 250 beats/minutes (1 beat/minutes steps)
: ±0.2%
Tempo accuracy
Metronome beats
: 0 – 9 beats, triplets
Note setting range
: C4 – B4 (in half-tone steps)
Standard pitch setting range : 438 – 445 Hz (1 Hz steps)
Standard pitch accuracy : ±1 cent
Clock Functions
: 12-hour clock
Indicators
: Liquid Crystal Display, Tempo Lamp (LEDx10)
Power Source
: Metronome/Note Function: 9V Dry Cell Battery (006P or 6F22) x1.
Clock: Lithium Battery (CR2025) x1.
Battery Life
: Metronome/Note Function: about 3 hours of continuos use.
Clock: About 1 year.
Dimensions (W x H x D) : 175 x 79 x 52 mm (6.9" x 3.1" x 2.0")
Weight
(including batteries)
: 240 g (8.5 oz)
Accessories
: Lithium battery (CR-2025) x 1, 9V dry cell battery (6F22) x 1
* Specifications and design subject to change without notice.
FCC INFORMATION (U.S.A.)
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions contained in this manual, meets
FCC requirements. Modifications not expressly approved by Yamaha may void your author-
ity, granted by the FCC, to use the product.
2. IMPORTANT:
When connecting this product to accessories and/or another product use
only high quality shielded cables. Cable/s supplied with this product MUST be used. Follow
all installation instructions. Failure to follow instructions could void your FCC authorization to
use this product in the USA.
3. NOTE:
This product has been tested and found to comply with the requirements listed in
FCC Regulations, Part 15 for Class "B" digital devices. Compliance with these requirements
provides a reasonable level of assurance that your use of this product in a residential
environment will not result in harmful interference with other electronic devices. This equip-
ment generates/uses radio frequencies and, if not installed and used according to the in-
structions found in the users manual, may cause interference harmful to the operation of
other electronic devices. Compliance with FCC regulations does not guarantee that interfer-
ence will not occur in all installations. If this product is found to be the source of interfer-
ence, which can be determined by turning the unit "OFF" and "ON", please try to eliminate
the problem by using one of the following measures:
Relocate either this product or the device that is being affected by the interference.
Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install
AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in
is 300 ohm ribbon lead, change the lead-in to co-axial type cable.
If these corrective measures do not produce satisfactory results, please contact the local
retailer authorized to distribute this type of product. If you can not locate the appropriate,
please contact Yamaha Corporation of America, Electronic Service Division, 6600 Orangethorpe
Ave, Buena Park, CA 90620
The above statements apply ONLY to those products distributed by Yamaha Cor-
porations of America or its subsidiaries.
持込修理
品 名 ／ 品 番
クォーツメトロノーム／QT-2 製番
本体：お買上げの日から1ヶ年間
保 証 期 間
年 月 日
※お買上げ日
ご住所 〒
お
客
様
お名前 様
電 話 （ ）
※
店
名
印
販
住
所
売
店
（ ）
電
話
ご販売店様へ ※印欄は必ずご記入してお渡しください。
Battery holder
Lithium battery
(CR-2025)
6F22 or 006P
9V dry cell battery
I COMPONENTS
G Front Panel
w Tempo indicator
r Speaker
QT-2
QUARTZ METRONOME
t Mode Select Switch
(Metronome <-> Note Function)
u Time (Hour)
Set Switch
G Rear Panel
o Tempo Dial
Pitch Dial
!0 Power switch
OFF
ON
POWER
MODEL QT-2
BATTERY 9V 6F22/CR2025
I OPERATION
G Using the Metronome (Metronome mode).
The beat can be set from 0 to 9 beats per measure or to a triplet feel. The
tempo can be set from 30 to 250 beats per minute.
1. Press the POWER switch and the metronome will start. Press the MODE switch to
switch between the Note Function mode and the Metronome Function mode.
2. Press the BEAT/NOTE switch to set the beat. Press the switch once to change the
value by one. The value is shown on the LCD display (0-1-2...-9-triplet-0).
3. Rotate the Tempo dial to set the tempo. The tempo value (beats per minute) is
shown on the LCD display (30-250).
4. The tempo lamps scan in time with the set tempo. The lamps on the far left and right
sides indicate strong beats.
5. Rotate the VOLUME dial to set the volume to a desired level.
6. Press the MUTE switch to use the metronome without sound. Press the switch once
to mute the metronome, press again to hear the metronome. The MUTE switch can
be used to start and stop the metronome while practicing.
G Selecting the note and setting the standard pitch (Note Function Mode).
The note can be set to any tone or half-tone within a one octave range of C to B.
1. Press the POWER switch and the metronome will start. Press the MODE switch to
change the mode from Metronome Function to Note Function.
2. Press the BEAT/NOTE switch to set the desired note. Every time the switch is
pressed, the note will increase in half-steps and be shown on the LCD display (C -
C# - D ... - A# - B - C).
3. Rotate the Pitch dial to set the standard pitch (A=438 – 445). The pitch setting will be
shown on the LCD display.
4. Rotate the VOLUME dial to set the volume to a desired level.
5. Press the MUTE switch to silence the Note Function's tone. Press the switch once to
mute the tone, press again to hear the tone.
* The standard pitch (438 – 445) will always be set for the note A.
G Clock Function: To set the time.
When the POWER switch is set to "OFF", the time will be shown on the LCD display.
To set the time, switch the POWER "OFF". Then use the hour and minute switches,
located underneath the unit, to set the time.
Each time the hour or minute switch is pressed, the corresponding value will increase
by one. When the button is kept pressed, the value will increase continuously. When
the minute switch is released, the seconds value will be reset to "0".
G Using the PHONES and INPUT jacks
• PHONES
This connector is a stereo mini jack. The internal speaker will be shut off
when a pair of headphones is connected to this jack. The MUTE switch
can be used to switch the sound off and on.
• INPUT
This connector is a stereo mini jack. The internal speaker will be shut off
when the INPUT jack is used. As shown in the diagram below, connect
an external sound source's (Clavinova, Silent Piano, Silent Brass, etc.,)
headphone jack to the QT-2. Both the sound source and the metronome
can be heard through headphones connected to the QT-2 without
disturbing others.
• The volume of the external sound source is not controlled by the QT-
2's VOLUME dial. Adjust the volume with the volume control on the
external sound source.
• When a monaural connector is used with the INPUT jack, the
PHONES jack's output will be monaural.
External Sound Source with
Headphone Jack
Headphone
Jack
• Refer to the diagram below to choose the type of connecting cord according to the
external sound source's headphone jack. If the external sound source's headphone
jack is monaural, use a connecting cord with monaural connectors at both ends.
External Sound
Source's
Headphone Jack
Stereo
Stereo Standard Type
Standard
Type
Stereo Standard Type
Adaptor Plug
Stereo Mini
Stereo Mini
Type
THIS DIGITAL APPARATUS DOES NOT EXCEED THE "CLASS B"
LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARA-
TUS SET OUT IN THE RADIO INTERFERENCE REGULATION OF
THE CANADIAN DEPARTMENT OF COMMUNICATIONS.
保証書
この度はヤマハ・クォーツメトロノームをお買上げ戴きましてありがとう
ございました。
本書は、本書記載内容で修理を行なう事をお約束するものです。お買上げ
の日から左記期間中に故障が発生した場合は、本書をご提示の上お買上げ
の販売店に修理をご依頼ください。 （詳細は裏面をご覧ください）
修理（サービス）メモ
年 月 日
内 容
q Mute switch
MUTE
e LCD display
3
MODE
BEAT
NOTE
y Beat Set Switch
(Metronome Mode)
Note Set Switch
(Note Function Mode)
i Time (Minute)
Set Switch
HOUR
MINUTE
(Metronome Mode)
(Note Function Mode)
!1 Volume
VOLUME
N89
INPUT
PHONES
MADE IN CHINA
!2 Input jack
!3 Phones jack
QT-2
OFF
ON
POWER
VOLUME
MODEL QT-2
N89
BATTERY 9V 6F22/CR2025
MADE IN CHINA
INPUT
PHONES
INPUT
PHONES
Connecting Cord *
Connecting Cord Type
Stereo Mini
Stereo Mini
Stereo Mini
Stereo Mini
Printed in Hong Kong 9611 R1
担 当 者
弦打楽器営業部 営業課
〒430 静岡県浜松市中沢町10番1号053-460-2433
Headphones
QT-2
INPUT Jack
Stereo Mini
Type
印
Publicité
