Jimmy F2 Mode D'emploi page 8

it will cause electric shock or fire due to short circuit.
Please do not use with the air inlet damaged, otherwise hair may get caught in the air inlet and
cause hair damage.
If the product accidentally falls into the water, please unplug it immediately, never put your hand
in the water.
For the purpose of protection, it is recommended to install 30mA RCD, please ask local RCD
installation agent for detail information.
Clean the socket regularly to prevent dust from accumulating, otherwise it will cause insulation
fault due to humidity, eventually causing fire. Disconnect the power immediately and clean it with
dry cloth.
Please do not twist the power cord when unplugging it. Please be sure to hold the power plug
with your hand and pull it out, otherwise it will cause power cord cut, which might cause scald,
electric shock or fire due to short circuit.
Please stop using the machine If you see the fire in the outlet during hot wind mode, clean the
dust in the inlet and outlet, otherwise it might cause scald or fire.
Please do not store the power cord when it is twisted, otherwise it will cause power cord cut,
which might cause scald, electric shock or fire due to short circuit.
The product is only for drying hair, please do not use to dry shoes or clothes etc., otherwise it
will cause electric shock or fire due to short circuit.
Please keep the distance of more than 10cm between inlet and hair, avoiding hair from
entangling into the hair dryer.
Please keep the distance of more than 3cm between hair and outlet to avoid scald.
The hair dryer is equipped with overheating protection system, the power will be cut
automatically when it is over-heated.
And switch off and unplug immediately, let it cool down for a minute.
Check if there is some fluff or hair in the inlet or outlet, then switch on again.
After use, please be sure to set the power switch to the "0" position and unplug the power plug
from the socket, otherwise it may cause burns or fire.
If the power cord is damaged, to avoid danger, it must be replaced by a professional from the
manufacturer, its service department, or a similar department. Failure to do so may result in
accidents or injuries.
6