Canvas PALMA 088-0743-4 Instructions D'assemblage page 4

6
MODEL No. 088-0743-4
Step 1
A, B, AA, BB
Requires
Line up the bolt holes on the table top (A) with the corresponding bolt holes on
the table legs (B). Insert M6x18 screws (D) on with flat washer (E) and tighten
using allen wrench (F). (*Reminder - Do not completely tighten screws). Repeat
this step until both table legs (B) are connected to table top (A).
AA
BB
B
A
AA
BB
Step 2
A, B, C, AA, BB, CC
Requires
Place the leg connector bracket (C) between the table legs (B). Attach table
legs (B) to leg connector bracket (C) by lining up screw holes on the legs (B)
with corresponding screw holes on the leg connector bracket (C). Insert the
M6x18 screws (D) with flat washer (E) and tighten using allen wrench (F).
(*Reminder - Do not completely tighten screws.) Repeat this step until both
legs (B) are secured to the leg connector bracket (C).
AA
AA
BB
BB
B
A
Step 3
Now tighten all the screws using the hex wrench (CC). Turn the table to upright
position on a flat, level surface. You are ready to enjoy your new table now.
AA
AA
BB
BB
C
7