König HC-SH20N Mode D'emploi page 2

Please handle the product with care, to prevent damage to the shower head.
You are strongly recommended to read and follow the manual carefully before
use. Please do not use the product in a corrosive environment; otherwise the
product will not work properly for a long time.
Features of LED shower head
Material:
Ambient temperature:
Ambient humidity:
Minimum water pressure: 0.2 MPa
Multicolour with temperature control
Green colour:
Blue colour:
Red colour:
Above 46 °C RED colour will flash
LED Quantity
8 high brightness LEDs with a diameter of 5 mm.
Instructions for use
After the LED shower is well installed, open the tap, the power generation
device inside LED shower will be driven to make LED light when water pressure
reaches 0.2 MPa.
Installation
Step 1: Put LED Shower Head onto hose that connects with water pipe;
Step 2: Open the tap completely, then LED shower will work properly.
Note: If LED shower is not working properly, please check if water pressure
reaches 0.2 MPa.
If LED shower still fails to work, please contact your supplier.
ABS, Electroplating
0–60 °C
10–90%
temperature lower than 32 °C
temperature between 33 and 41 °C
temperature between 42 and 45 °C
2
ENGLISH