Aleratec Charge and Guard Secure Charge/Sync Cabinet 16 Guide De Démarrage Rapide page 10

Using the Charge and Guard Secure
Charging or Syncing Your Devices
1. If syncing, use the USB A/M to B/M cable provided and connect the
USB B end to the unit. Connect the USB A end to your host computer.
Unplug this USB cable if charging your tablets.
Sync times will vary greatly depending on a variety of factors
including, but not limited to, your computer and the amount of
data being synced. After syncing, eject each device individually as
approprite on your connected computer.
Please note that this station only serves as a pathway for
communication between your devices and the computer. Actual
management and synchronization is handled by software or apps
independent of this station.
After syncing, eject each device properly from the computer before
disconnecting or powering off.
2. Insert each tablet or other USB-charged device into your cabinet.
8 www.aleratec.com