Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The range hood is designed to remove smoke, cooking
vapors, and odors from the cooktop area. For best results,
start the hood before cooking and allow it to operate several
minutes after the cooking is complete to clear all smoke and
odors from the kitchen. The hood controls are located on the
front side of the canopy.
A
B
Buttons
A. Blower ON/OFF and decrease speed button
B. Blower ON and increase speed button
H. Delay off
I. Light button
Operating the light
The
button controls both lights. Press once for ON and again
for OFF. When button is pressed and lights are on the indicator G
will display.
Operating the blower
The blower can be turned on with both decrease and increase
buttons. To turn on and off the hood and decrease speed use
button A. To turn on the hood and increase speed up to 4
different speeds (low, medium, high and boost) use button B.
When Boost speed is on hood will be activated at maximum
speed for 5 minutes. After 5 minutes, the hood will slow to
medium speed.
Timer
The range hood can be set to automatically turn off after
5 minutes.
With the desired fan speed activated, press the Delay off button.
The fan will run on the chosen speed for 5 minutes, after 5
minutes, the fan will turn off automatically.
Pressing the Delay off button will cancel the 5-minute timer.
10
RANGE HOOD USE
A. Grease filter
B. Grease filter handle
C. Blower and light controls
D. LED lights
Range Hood Controls
C
D
E
The LCD screen displays:
Following filter maintenance, hold H button down until the
indicator goes off.
The charcoal filter saturation indicator should only be activated
in Recirculation mode.
To activate it, make sure that the hood is switched off and
then press buttons A and H at the same time until the indicator
changes from a flashing light to a fixed light. Repeat the
procedure to deactivate the function.
The hood is equipped with a temperature sensor. In the event of
a sudden temperature surge, the hood activates extraction until
the temperature has dropped significantly.
F
G
Indicators
C. Blower speed indicator
D. Charcoal filter saturation
E. Grease filter saturation
F. Delay off
G. Light
LCD screen
C. Extraction speed level indicator: the icon increases the
amount of lines around the blower according to the selected
speed.
D. Grease filter saturation indicator.
E. Charcoal filter saturation indicator (only in Recirculation
mode).
F. Automatic power-off timer indicator.
G. Lighting indicator.
Resetting the Filter Saturation Indicator
Activating the Active Charcoal Filter Saturation
Indicator
Automatic Operation at High Temperature
H
I
Publicité
Table des Matières
