Product Description - Bellman & Symfon BE1033 Mode D'emploi

Adjustments
You can adjust the volume with the large red volume control on the top of the receiver. The sound
signal on the front can be switched off with the sliding switch located on the back of the receiver.
Trouble shooting
A fault is not always serious. Follow the trouble shooting chart below before calling for service.
Symptom
The receiver does not receive signals from the door
or telephone transmitter.
The receiver signals although no one has rung the
door bell or telephone.

Product description

1) Volume control
2) Indicator lamp
3) Flash signal
4) Bed-shaker output
5) Connection, mains adapter
Action
Press in the receiver's test button for a few seconds.
The test lamp should then shine green and the
receiver should emit a sound signal.
If it shines red or not at all the batteries in the
receiver must be changed.
Change the radio channel rst in all Visit transmit-
ters and then in the receiver.
6) Battery panel
7) Sound signal on/off
8) Test button
15