Table des Matières
Publicité
TOX-PRESSOTECHNIK L L C
MR. ERIC SEIFERTH
4250 Weaver Pkwy
Warrenville, IL, 60555-3924 USA
Our Reference:
File E503298, Vol. D1
Your Reference:
Models EPW 400, Smart9 T070E, Smart9 T057, STE 341-xxx T070, STE346-0005, CEP
400T, Touch Screen PLC's
Project Scope:
UL Listing to the following standard(s):
UL 61010-1, 3rd Edition, May 11, 2012, Revised April 29 2016, CAN/CSA-C22.2 No.
61010-1-12, 3rd Edition, Revision dated April 29 2016
Subject:
Notice of Project Completion with Initial Production Inspection
Dear MR. ERIC SEIFERTH:
Congratulations! UL's investigation of your product(s) has been completed under the above Reference Numbers and
the product was determined to comply with the applicable requirements. The Test Report and records in the Follow-
Up Services Procedure covering the product are completed and are now being prepared (if you do not have a
separate CB Report, you can to access the Test Report now). Please have the appropriate person in your
company that is responsible for receiving/managing UL reports access an electronic copy of the Test Report
and FUS Procedure through the CDA feature on MyHome@UL, or if you desire another method of receiving
the report please contact one of the contacts below. If you are not familiar with our MyHome site or need to
create a new account in order to access your reports, please click the link HERE.
PLEASE NOTE: YOU ARE NOT AUTHORIZED TO SHIP ANY PRODUCTS BEARING ANY UL MARKS UNTIL
THE INITIAL PRODUCTION INSPECTION HAS BEEN SUCCESSFULLY CONDUCTED BY THE UL FIELD
REPRESENTATIVE.
An Initial Production Inspection (IPI) is an inspection that must be conducted prior to the first shipment of products
bearing the UL Mark. This is to ensure that products being manufactured are in accordance with UL LLC's
requirements including the Follow-Up Service Procedure. After the UL Representative has verified compliance of your
product(s) at the manufacturing locations listed below, authorization will be granted for shipment of product(s) bearing
the appropriate UL Marks as denoted in the Procedure (located in the FUS Documentation of the report).
List of all manufacturing locations (please contact us if any are missing):
Manufacturing
TOX PRESSOTECHNIK GMBH & CO. KG
Facility(ies):
Riedstraße 4
88250 Weingarten Germany
Contact Name:
Contact Phone No.:
Contact Email:
It is the responsibility of TOX-PRESSOTECHNIK L L C, the Applicant, to inform its manufacturers of that the IPI must
be successfully completed before product may be shipped with the UL Mark. Instructions for the IPI will be sent to
our inspection center nearest to each of your manufacturing locations. The contact information of the inspection
center is provided above. Please contact the inspection center to schedule the IPI and ask any questions you may
have regarding the IPI.
Inspections at your production facility will be conducted under the supervision of:
NOTICE OF COMPLETION
INITIAL PRODUCTION INSPECTION
Eric Seiferth
1 630 447-4615
ESEIFERTH@TOX-US.COM
Area Manager:
ROB GEUIJEN
IC Name:
UL INSPECTION CENTER GERMANY,
Address:
UL INTERNATIONAL GERMANY GMBH
ADMIRAL-ROSENDAHL-STRASSE 9, NEU-
ISENBURG, Germany, 63263
Contact Phone:
69-489810-0
Page 1
AND
Project Number:
2019-08-30
4788525144
Publicité
Table des Matières
