Samsung BIXOLON SRP-350 Guide De L'utilisateur page 23

GS B n
[Name] Turn white/black reverse printing mode on/off.
[Format] ASCII GS B n
Hex 1D 42 n
Decimal 29 66 n
0 ≤n ≤255
[Range]
[Description] Turns on or off white/black reverse printing mode.
* When the LSB is 0, white/black reverse printing mode is turned off.
* When the LSB is 1, white/black reverse printing mode is turned on.
GS H n
[Name] Select printing position of HRI characters.
[Format] ASCII GS B n
Hex 1D 48 n
Decimal 29 72 n
[Description] Selects the printing position of HRI characters when printing a bar code.
n selects the printing position as follows :
n Printing position
0, 48 Not printed.
1, 49 Above bar code.
2, 50 Below bar code.
3, 51 Both above and below the bar code.
* HRI indicates Human Readable Interpretation.
GS I n
[Name] Transmit printer ID.
[Format] ASCII GS I n
Hex 1D 49 n
Decimal 29 73 n
1 ≤n ≤3, 49 ≤n ≤51
[Range]
[Description] Transmits the printer ID specified by n as follows :
n Printer ID
1, 49 Printer model ID SRP-350 series
2, 50 Type ID
3, 51 ROM version ID Depends on ROM version
42
Specification ID (hexadecimal)
20
02
02
GS L nL nH
[Name] Set left margin.
[Format] ASCII GS L nL
Hex 1D 4C nL
Decimal 29 76 nL
0 ≤nL ≤255, 0 ≤nH ≤255
[Range]
[Description] Sets the left margin using nL and nH.
* The left margin is set to [(nL + nH ×256) ×horizontal motion unit]
inches.
GS P x y
[Name] Set horizontal and vertical motion units.
[Format] ASCII GS P x
Hex 1D 50 x
Decimal 29 80 x
[Range] 0 ≤x ≤255, 0 ≤y ≤255
[Description] Sets the horizontal and vertical motion units to approximately 25.4/x mm
{1/x inch and } and approximately 25.4/y mm {1/y inches }, respectively.
When x and y are set to 0, the default setting of each value is used.
① GS V m , ② GS V m n
[Name] Select cut mode and cut paper.
① ASCII GS V
[Format]
Hex 1D 56
Decimal 29 86
① m = 0,1,48,49
[Range]
[Description] Selects a mode for cutting paper and executes paper cutting.
The value of m selects the mode as follows :
m Print mode
0,1,49 Partial cut (one point left uncut)
Feeds paper (cutting position + [nX(vertical motion unit)]),
66
and cuts the paper partially (one point uncut).
43
nH
nH
nH
y
y
y
m ② ASCII GS V m n
m Hex 1D 56 m n
m Decimal 29 86 m n
② m = 65,66, 0 ≤n ≤255