H
FILTERS
1. METAL FILTERS
Open the panel (see fig. H3). Use handle A to remove the metal grease
filter.
2. CHARCOAL FILTERS
To replace the charcoal filters, proceed as follows: remove the metal filters
as described above. The two filters located at the ends of the motor can
now be easily accessed.
To install the new fi lters see picture.
To order new filters, use the coupon enclosed with this booklet or provided
by the distributor.
3. REMOVABLE PANEL
Follow the instructions on fig. H3 to remove the panel.
I
LIGHTING
SPOTLIGHT
How to replace a square halogen light:
a) Check that the equipment is disconnected from the power supply.
b) Open the panel completely till 90° (see figure) pressing the PUSH button
c) Replace the lamp with a similar one (halogen, max 20 W, 12 Volt, G4 con-
nection).
d) Close the panel. If the panel does not close correctly repeat the operation
at point b.
22
REMOVING AND REPLACING'S INSTRUCTIONS
A
ASSEMBLY AND REPLACEMENT