Blowing Operation - Build Worker BVC1100-18SS Mode D'emploi

This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN
CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING:
KEEP BYSTANDERS CLEAR FOR BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
INHALED.
1. Verify that the power cord is disconnected from the outlet.
2. Make sure the container is empty before using as a blower.
3. Remove hose from the vacuum port.
4. Insert the larger end of the hose into the blowing port on the back side of the power head.
(fig.1)
5. Fit the desired attachment to the hose. (fig. 2)
6. Ensure the power switch is turned OFF and plug into the power supply. (fig.3)
7. Before turning ON the vac, firmly hold the loose end of the hose. Turn the motor on by
pressing the switch to the 'I' ON position. (fig.4)

BLOWING OPERATION

39