Refco OCTA-WIRELESS-CONTROL-BOX Mode D'emploi page 2

OCTA-WIRELESS-CONTROL-BOX
Replacement
1. Install the batteries for the control box
(receiver) and the platform (transmitter)
2. Shut off the control box and the
platform
3. While holding the
UNITS
The button
Release both buttons until display
shows
4. Turn on the transmitter of the platform
The LED light on the transmitter flashes and sends
the ID code within 2-3 seconds
button, press
The control box reads the ID code of the
transmitter and shows it on the display
(Ex. 295 )
5. Press the button to confirm. The
SET
display reads and ends the ID setting
888.88.8
mode.
6. Perform factory calibration:
see OCTA-WIRELESS user manual
Caution:
The ID setting must be performed 1:1 (one
platform to one control box)
Ensure that there is no interference when
completing the ID setting
If the control box does not receive and
display the the ID code sent by the
transmitter (within 2-3 seconds):
Restart the transmitter