Maintenance; Motor Maintenance; General Maintenance - Ryobi UPROAR P3800 Manuel D'utilisation

NOTE: Always turn the controller ON before turning the
truck ON. Always turn the truck OFF before turning the
controller OFF.
 Slowly drive the truck a short distance forward and
backward.
 Slowly drive the truck in circles.
 Slowly drive the car in figure eights.
 Repeat the steps above while gradually increasing the
speed of the truck.
NOTE: Impact with a wall or other solid object will cause
the truck's motor to stop.
To reset the truck:
 Turn the truck's switch OFF and then back ON.
The truck performs best on asphalt or concrete surfaces. For
best operation, never drive the truck on an uneven surface,
in water, or around moving vehicles.
WARNING:
When servicing, use only identical replacement parts.
Use of any other part could create a hazard or cause
product damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
NOTE: ILLUSTRATIONS START ON PAGE 9 FOLLOWING FRENCH AND
OPERATION

MAINTENANCE

SPANISH LANGUAGE SECTIONS
7 — English
NOTICE:
To avoid damage to the truck, never drive it through a
puddle, on sand, on wet grass, or in mud, rain, or snow.
The truck will stop if outside of the controller's 300 foot
range. Move within 300 feet of the truck to get moving again.
If the truck is moving slowly and the battery is charged, turn
the truck OFF, then turn the controller OFF, and check the
wheel mechanisms for lint, thread, hair, or dust.
This product uses lithium-ion (Li-ion) batteries. Local, state
or federal laws may prohibit disposal of batteries in ordinary
trash. Consult your local waste authority for information
regarding available recycling and/or disposal options.

MOTOR MAINTENANCE

The brushed motor needs to be cleaned periodically using
an electric motor cleaning spray, available from your local
hobby store. Spray the brushes and commutator inside the
motor housing to keep the motor running properly. After
cleaning, use a thin bearing oil to lubricate the bearings of
the bushings.