Cleaning And Maintenance; Technical Specifications - ECG FS 91 T Mode D'emploi

Masquer les pouces Voir aussi pour FS 91 T:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
NIGHT: Program SLEEP is a combination of the SUMMER mode and gradual reduction of the fan speed.
When you set high speed , the fan will run in the first 30 minutes in SUMMER mode at high speed. It will
1.
reduce speed after 30 minutes to medium and after next 30 minutes the fan moves to low speed in the
SUMMER mode, where it remains until shutoff.
When you set medium speed, the fan will run the first 30 minutes in the SUMMER mode at medium speed.
2.
In the next 30 minutes it switches to low rpm in the SUMMER mode where it remains until shutoff.
3.
When setting a low speed, the SLEEP mode is the same as the SUMMER mode at low rpm.
SWING 4
Press the button SWING once. The fan starts to oscillate in the horizontal plane and the LED indicator lights up.
Press again to switch off the oscillation.
Note: Using tabs protruding on the front cover you can mechanically set the vertical incline of the inner slats.
OFF 3
Press OFF button to turn off the appliance and the fan stops.
When you are not using the device, always unplug the power cord from the electrical outlet.

CLEANING AND MAINTENANCE

Before cleaning pull out the plug of the power cord from the outlet!
Use soft, dry cloth for cleaning. Do not use solvents or other chemicals.
Make sure that no liquid enters the device.
If the fan is not used for long time, it is necessary to protect it from dust and moisture. We recommend that
you store it in its original packaging.
In the event of a malfunction or an unusual odor, unplug the appliance from the power supply and have it
checked by an authorized service center.
Check it once a week and using a vacuum cleaner clean the back grill of the fan.
We recommend to keep the packaging for possible transportation or storage of the fan.

TECHNICAL SPECIFICATIONS

Nominal voltage:
Nominal input power:
Noise level:
Remote control:
WARRANTY: The following situations void the warranty:
Incorrect or inappropriate handling of the device, failure to observe safety measures applicable to the device,
the use of force, alterations or repairs made by a party other than authorized service center.
Components subject to normal wear and tear are not covered under warranty.
220–240 V~ 50 Hz
65 W
60.5 dB
Coin battery (CR2032 3V included)
7

Publicité

Table des Matières
loading

Table des Matières