Nuface MINI Manuel D'utilisation page 5

WA R N I N G S (CO N T I N U E D)
• Do not operate Mini Device in the presence of electronic monitoring equipment (e.g., heart
monitors, heart tracing or in close proximity (e.g. 1 m) to shortwave, microwave or electromagnetic
therapy equipment as it may cause the medical equipment to malfunction. Such equipment may
produce instability in Mini Device output and cause burns at the stimulation site.
• Do not apply stimulation while bathing or showering.
• Do not use this device when there is a tendency to bleed following acute injury or breaks in bones.
• Do not apply stimulation over areas of skin that lack normal sensation.
• Device should not be used at extreme temperatures.
• Keep this device out of the reach of children and pets.
• Discontinue using the device immediately if you suspect the device to be malfunctioning, or not
operating properly. Return the device to NuFACE for examination.
• Do not disassemble the device as this may cause damage, malfunction, electrical shock, fire or
injury. There are no user-serviceable parts inside. Note: Disassembly voids the warranty.
P R E C AU T I O N S
The NuFACE Mini Device is designed for cosmetic use only and for individuals in good health.
If this is not the case for you, please consult your healthcare provider before use.
• The long-term effects of transcutaneous electrical stimulators are unknown.
• If you have suspected or diagnosed heart disease, you should follow precautions recommended
by your healthcare provider.
• Some users may experience skin irritation or hypersensitivity due to the electrical stimulation or
conductive Gel. Irritation can usually be reduced by using an alternate NuFACE conductive medium.
• Skin irritation and burns beneath the electrodes have been reported with the use of other powered
muscle stimulators. If you experience skin irritation or burning, discontinue use immediately.
• If using the Mini Device causes persistent pain or discomfort, discontinue use immediately.
• A slight tingling sensation may occur while using the Mini Device. Lowering the intensity may
reduce or eliminate this sensation.
• There may be a perception of flashing lights during the use of your Mini Device, resulting from the
stimulation of the eye area. If you notice this condition constantly without the use of your device,
consult your healthcare provider.
• Some users may experience a metallic taste in their mouth during the use of your device, resulting
from stimulation and varying sensitivity around the mouth. If you notice this condition constantly
without the use of your device, consult your healthcare provider.
• The battery of the device is not removable by the user. If the device is to be disposed of, do not
put into a fire. Dispose of the device per local regulations.
• Inspect the device and do not use the device if you see any signs of internal battery leaks.
• The Mini Device is intended to be stored and used at room temperature. Do not store Mini Device
in the sun or on a hot surface. High temperatures may be damaging. The device should be operated,
transported and stored in the manner specified in this manual. Failure to use and maintain the device
in accordance with the instructions outlined in this manual will void the warranty.
• Only use the power adapter provided with the Mini Device.
• The NuFACE Mini Device is intended for cosmetic use on the face as described. Any consequence
resulting from misuse, application to other parts of the body or face, connection to improper voltage
sources, dirty spheres, expired on non-NuFACE conductive alternative, or any other improper
application is neither the responsibility of NuFACE nor its affiliates.
G E T T I N G STA R T E D
FOLLOW THESE IMPORTANT STEPS BEFORE USING YOUR NEW DEVICE.
1) Remove your Mini Device and power adapter from the box.
2) Connect the power adapter to the device and plug into the wall outlet, safely away from any
source of water, to charge your device. Note: The Mini Device will not turn on when it is charging.
3) Place your Mini Device on a counter or table top, away from any source of water.
4) Important: Charge your Mini Device for 12 hours before the first use.
The lights will increasingly illuminate, indicating that your device is charging. All the lights will stay
illuminated when device is fully charged.
5) Important: Test your skin to make sure you are not sensitive to the NuFACE Gel Primer.
To do so, rub a dime-sized amount of primer on your forearm and leave for 15-30 minutes before
washing it off. If an allergic reaction (rash, redness, etc) develops, immediately contact NuFACE
for recommendations on alternative NuFACE formulas. You should not initiate treatment with the
Mini Device until your reaction to the primer has been resolved.
5
NF_Mini_UserManual_ForPrint042919.indd 9
6) Remember to take a before photo of your cleansed face in a well-lit room. After your first
treatment, take an after photo and repeat the process in the same well-lit room every 4 weeks to
track your results.
D E V I C E S O U N D I N D I C AT E S
Ascending Beeps Powered ON
Descending Beeps Powered OFF
Single Beep
Intensity Adjusted
Dual-Tone Beep End of Glide Interval
Two Descending Beeps Battery Needs To Be Charged
H Y D R AT I N G L E AV E - O N G E L P R I M E R
The essential first step to your microcurrent treatment to ensure optimal results.
Important: Always apply Gel Primer when using the Mini Device.
Refer to packaging for use by date.
T R E AT M E N T A R E A S
The Mini Device is designed to stimulate large surface areas of the face and neck, such as the jawline,
cheekbones and forehead. Avoid applying the device to the midline of the neck. Follow instructions
below for best results, and refer to your Quick Start for more detailed images.
T R E AT M E N T T E C H N I Q U E
Using light to medium pressure, lift one side of the face and neck at a time using a gliding motion.
Important: Always ensure that both spheres are in contact with the skin during treatment. Refer to
your Quick Start for basic glides treatment for the neck, cheeks, and forehead. For more advanced
treatment options and holds, visit our website at MyNuFACE.com
H OW TO U S E YO U R M I N I D E V I C E
GET READY TO TONE, LIFT, AND CONTOUR.
The instructions below are designed to provide the most effective results when followed correctly.
1) Cleanse your face and neck with an oil-free cleanser. Men should shave before treatment — facial
hair can interfere with the conductivity of the spheres. Note: Any cream, lotion, self tanner, and/or
oil-based products on the skin can block the microcurrent.
2) Apply a mask-like layer of the NuFACE Gel Primer section by section as you treat.
Note: Always apply a NuFACE gel primer when using your Mini Device.
Reapply if skin becomes dry during treatment to avoid any uncomfortable sensations.
3) Remove the power adapter from the device and turn it ON by pressing the ON/OFF button.
An ascending audible beep is emitted notifying you that your device is ON.
4) Adjust the intensity level to your comfort by progressively pressing the ON/OFF button
to increase or decrease the microcurrent output. As you toggle between the 3 intensity levels,
an audible beep is emitted and the number of illuminated blue lights will change.
Intensity Levels:
• Minimum Intensity: Left 2 Lights Illuminated
• Medium Intensity: Middle 3 Lights Illuminated
• Maximum Intensity: Right 2 Lights Illuminated
5) Place the Mini Device in direct contact with the treatment area. Always keep both spheres
in contact with the skin during treatment to keep microcurrent flowing. Using light to medium
pressure, begin your treatment. Note: Facial skin sensitivity varies from person to person.
It's completely normal to not feel any sensation at all. If you do experience tingling, avoid hair
follicles and add more Gel Primer to the area you are treating. The Mini Device will NOT contract
the muscles when used as instructed.
6) The device emits a dual-tone beep every five (5) seconds to indicate when to move to the next
treatment area. The beep will change to two (2) low tones when the battery needs to be charged.
6
4/29/19 2:40 PM