Removing Collected Water; Water Level - GEA ADKW30 Manuel D'utilisation

Using the dehumidifier.
Always make sure the water bucket is locked into place on the dehumidifier.

Removing Collected Water

There are 2 ways to remove collected water:
Use the bucket. When the bucket is removed,
the unit will shut off. Empty and replace the
bucket.
IMPORTANT: Do not use the drain tube if using
the bucket to collect water. When the drain tube
is connected, water will flow through it onto the
floor instead of into the bucket.
NOTES:
n Do not remove the bucket while the
dehumidifier is operating or if it has just
stopped operating. This might cause some
water to drip from the drain pan.
n The bucket must be in place and securely
seated for the dehumidifier to operate.
Use a hose. Water can be automatically
emptied into a floor drain by attaching the
unit's drain tube with nozzle and a garden
water hose (not included).
1. Remove the bucket from the front of
the unit.
2. Remove the plug cover from the back of
the unit and store it in a safe location.
3. Insert the tube through the hole in the back
of the unit and securely press it onto the
connector on the front of the unit. Push the
tube around the front connector until the
nozzle is flush with the back of the unit.
Back of unit
Firmly press the tube
onto the front connector.

Water Level

The dehumidifier will turn off automatically
when the bucket is full, or when the bucket is
6
removed or not replaced in the proper position.
NOTE: Support bucket with
both hands when emptying.
Insert tube through
hole in back of unit.
Front of unit
4. Secure the nozzle to the back of the unit with
the two screws provided.
Back of unit
5. Cut (as needed) and thread a garden hose
(not supplied) onto the nozzle and lead it to
the floor drain.
Back of unit
6. Replace the bucket in the unit.
NOTE: The bucket must be in place and securely
seated for the dehumidifier to operate.
The bucket must be replaced in the proper position
for the dehumidifier to work. The light will be on and
the dehumidifier will not run if the bucket is not in the
proper position.