Operating Instructions - Clarke American Sanders Super E Manuel De L'utilisateur

ENGLISH
EN
MACHINE SET-UP
Preparing the machine for operation
1. Familiarize yourself with the machine. Read all
danger, warning, and caution statements and the
Owner's Manual before operating this machine. If
you or your operator cannot read English, have this
manual explained fully before attempting to operate
this machine.
2. Remove belt guard (figure 3-a). Position extension
over motor and start thumb screw (figure 3-b).
Position drive belt in lower most set of grooves
on motor pulley as shown in figure 4-a (for the
kick-toe extension with 7" dia. pad.) The upper
most set of grooves are reserved for use with all
other attachments. Tension drive belt, then tighten
thumb screws. Rotate pad driver to inspect
position of drive belt in motor pulley and pad driver
belt grooves.
CAUTION: Rapid belt wear will occur if both
strands of the drive belt do not run in
their respective grooves on the pad
driver and motor pulley.
3. Install belt guard.
4. Remove screw and abrasive retainer. Center
abrasive on pad and secure with abrasive retainer
and screw. (Figure 4-b)
5. Return machine to upright position and tilt machine
back on casters until it comes to rest on the
exhaust bracket. Machine will be in a reclined
position. Do not allow machine to rest on pad
especially after use, or compression set may take
place within elastomer on pad. This will create a
flat spot and bounce during use.

OPERATING INSTRUCTIONS

1. Move machine to the location of your work. Set any
exposed nails with hammer and punch to avoid
encounter with abrasive. Connect the supply cable to
an appropriately grounded and fused circuit.
WARNING: Bodily injury could occur if power is applied to
the machine with the control switch in the "ON"
position. Always verify that the control switch
is in the "OFF" position before connecting to the
power cable.
-8- ® Operator's Manual (EN) - Super E
Clarke American Sanders
Figure 3
Figure 4