EQUATION Eolto 1500 Manuel D'utilisation page 109

AVERTISSEMENT
• Electric wiring must be performed by a qualifi ed person in compliance with cur-
rent local and national regulations, and with instructions of this manual.
• Before connecting wires, make sure electric power is off .
• Use a dedicated electric circuit. A circuit whose capacity is too low or where
wiring is done incorrectly can cause electric shocks or fi res.
• If the supply cord is damaged, it must be replaced by the manufacturer, its ser-
vice agent or similarly qualifi ed persons in order to avoid a hazard.
• Means for disconnection must be incorporated in the fi xed wiring in accordance
with the wiring rules
• An energy management or power cut-off system is incompatible with this de-
vice. It damages the thermostat.
• The heater must not be located immediately below a socket outlet
• This device is IP24 protection and
can be installed in zones 2 and 3 of
the bathroom.
• Do not install a shelf above the ap-
pliance.
• Keep a free space of 50 cm in front of
the device.
• The low box should be at least 5mm
from the wall.
• When heating for the fi rst time, a slight odor may appear corresponding to the
removal of any traces associated with the manufacture of the appliance.
• The surface of the appliance can be very hot, please pay special attention if you
put delicate clothes on it (ex: Polyamide, ....). Make sure the laundry does not fade
before placing it on the towel warmer.
• This heater is fi lled with a precise quantity of heat transfer fl uid which is hazar-
dous to health if swallowed.
• Repairs requiring opening of the fl uid container are only to be made by the ma-
nufacturer or his service agent.
3
2
60 cm
1
60 cm
0
FR
ES
PT
IT
EL
PL
UA
RO
EN
109