Publicité
Les langues disponibles
Les langues disponibles
Installation
1. Firstly, be sure that the mains voltage matches the voltage marked on
the base of the laser lighting;
2. Installation should be made by professional technician. Fix the laser
lighting and adjust the angle of the laser lighting to your needs;
3. Please check whether the fan and the exhaust are blocked;
4. There is a hole for connection. When hang the laser lighting, be sure
the cable can undertake 10 times of the lighting weight;
5. The laser lighting should be fixed;
6. It is essential to be earthed well for the sake of safety.
DMX512
This laser light is controlled by the standard DMX. Please connect control
panel with the lighting as following
Before using the DMX512 controller, you should set the channel address.
It can be set 001 ~ 511 address. Every binary address switch has a digital
no. Please refer to:
No.
Digital No.
1st
1
2nd
2
3rd
4
4th
8
5th
16
Maintenance
Please clean the lens regularly. Do not use the wet cloth or other
chemical. The frequency depends on the usage and surrounding
conditions; it is recommended that it should be cleaned every 20 days;
Please clean the lighting surface and engine outlet regularly.
Be sure that there is no flammable or explosive subject nearby. The least
distance is 0.5 meters.
Warning
Power off before installation or maintenance. The danger class of this
laser lighting is CLASS 3B. it's dangerous to look into the laser beam. The
safe minimum distance is 50cm, the safe maximum time is 10 seconds;
Keep at least 0.5 meters distance between the lighting and inflammable
material.
© Copyright Lotronic 2010
No.
Digital No.
6th
32
7th
64
8th
128
9th
256
10th
Function switch
DMX Control Parameter Chart
DMX512
Channel No
fig.
0-139
Channel 1
Control
140-209
mode
210-255
Pattern
0-33
Channel 2
Selection
34-255
Channel 3
Strobe
0-255
Channel 4
Spot and line
0-255
1~160
Horizontal
161~190
Channel 5
move
191-220
221-255
1-160
Vertical
161-190
Channel 6
move
191-220
221-255
Zoom(+/-)
Channel 7
0-255
pattern size
Channel 8
No special
Channel 9
Reset
0-255
Channel
Gradually
0-255
10
paint
When the CH2 is selected the Static pattern mode (DMX value is 0--33),
you can use channel CH2, CH3-CH10 to control laser beam, otherwise
CH2, CH3-CH10 are invalid
Content
Black out
Auto play
manual
Static pattern
Dynamic
Geometric
pattern
8 grade speed
From line to spot effect
Manual
From left to right move
From right to left move
Right and left in-phase
move
Manual
From down to up
From up to down
Up and down in-phase
move
pattern size change
The number come to more
than 200, the machine
reset
Gradually paint
© Copyright Lotronic 2010
Publicité
