GE IM-4A Manuel D'utilisation Et D'installation page 23

4 INSTALL THE ICEMAKER FILL CUP
Install the icemaker fill cup (side-mounted) (15)
into the icemaker as shown.
5
PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the icemaker
power cord plug into the socket on the rear wall.
Press the plug firmly into the socket. Lock the plug
in place by clipping the restraints onto each side of
the plug. Make sure the restraints click into place.
Make sure the power cord is still in the hook on the
back of the icemaker.
Hook
Installation Instructions
15
23
6 MOUNT THE ICEMAKER
• Lift the icemaker so the fill tube (13) fits in the
fill cup opening (E). Hang the icemaker on the
two mounting screws (11).
Make sure:
• The power cord is still firmly in the socket.
• The fill tube (13) extends into the fill cup
opening on the back of the icemaker. (Check
the rear of the refrigerator to make sure the fill
tube has not been pushed out of the back of
the refrigerator).
• The icemaker mounting screws are located in
the uppermost position of the mounting slots.
• The icemaker is level.
THEN SECURELY TIGHTEN THE ICEMAKER
MOUNTING SCREWS.
7
INSTALL THE ICE BUCKET
Install the freezer shelf in the lowest position. Place
the ice bucket (9) on the shelf under the icemaker.
Make sure the icemaker power switch is set to O (off).
8 ATTACH WARRANTY LABEL
A label (7) is provided with this kit to record the
date of installation for warranty purposes. Apply it
to the back of the refrigerator.
9
KEEP THIS MANUAL
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
13
11
E
9