GE IM-4A Manuel D'utilisation Et D'installation page 11

4 SET POWER SWITCH TO O (off)
Set the icemaker power switch to O (off). Leave
the power switch in the O (off) position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
5 INSTALL THE ICEMAKER FILL CUP
Install the icemaker fill cup (side-mounted) (15)
into the icemaker as shown.
6 PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the icemaker
power cord plug into the socket, making sure that
the prongs and holes are matched. Press the plug
firmly into the socket. Lock the plug in place by
clipping the restraints onto each side of the plug.
Make sure the restraints click into place. Make sure
the power cord is still in the hook on the back of
the icemaker.
Hook
Installation Instructions
15
MOUNT THE ICEMAKER
7
• Lift the icemaker so the fill tube extension (8)
fits in the fill cup opening (C). Hang the
icemaker on the two mounting screws (A).
Make sure:
• The power cord is still firmly in the socket.
• The fill tube extension (8) is still in the fill cup
opening. (Check the rear of the refrigerator to
make sure the fill tube has not been pushed out
of the back of the refrigerator.)
• The icemaker mounting screws are located in
the uppermost position of the mounting slots.
• The icemaker is level.
THEN TIGHTEN THE ICEMAKER
MOUNTING SCREWS SECURELY.
8
INSTALL THE ICE BUCKET
Put the ice bucket (9) in
place under the icemaker.
Make sure the icemaker
power switch is set to
O (off).
9 ATTACH WARRANTY LABEL
A label (7) is provided with this kit to record the
date of installation for warranty purposes. Apply it
to the back of the refrigerator.
10 KEEP THIS MANUAL
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
11
8
A
C
9