Comunello R-CONTROL Mode D'emploi page 23

E Within 5 seconds press and hold for 5 seconds the key PROG of the transmitter 2 to be programmed.
F Set the transmitter dip-switch no. 1 of transmitters 1 and 2 into OFF position.
G Wait 10 seconds.
H Pressing the keys UP or DOWN the actuator moves in opening/closing direction.
5.7 DIP-SWITCH 3: DELETION OF ALL THE STORED TRANSMITTERS
To delete all the transmitters stored on the control unit it is necessary using a remote control previously stored and
proceed as follows:
A Power only the control unit to be reset.
B R6-CONTROL only: press the key SELC on the transmitter repeatedly until displayed the channel stored (by the
leds).
C Set the transmitter dip-switch no.3 into ON position.
D Press and hold for at least 10 seconds the key PROG of the transmitter.
E Leave the key PROG and set the remote dip-switch no.3 into OFF position.
E Release the key PROG and set on OFF the transmitter dip-switch no.3.
23