Publicité
Les langues disponibles
Les langues disponibles
English
1. To fix the tool holder to the machine,
use pins for positioning. Tighten the
2 fixing screws of fixations
(important, make sure that the
screws have the same clamping
force).
2.
Adjust the offset position of your
tool.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
DE13-0006
3.
4.
MARK :
empty positions. Use the supplied
protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation : 24.04.2017
During the mounting or dismounting of
your cutting tools, block the broach on
flats planned for that purpose, using
the supplied spanners.
The
tool shank diameter should never
have a difference of more than 0.4
mm compared to the clamping
diameter of collet
Example: clamping diameter 9.5 mm
=> Shank diameter 9.1 mm minimum.
Never use the tool holder with
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
DE13-0006 1-.
Mode
d'emploi.docx
Page : 2 de 4
Publicité
