Installation And Setup - Schuller Ehklar EASY SANDER DS 600 Manuel D'utilisation

GB Operation
Installation & Setup
DANGER!
STEP 1: Unfold the machine and attach the handle. (See Fig.1-1, Fig.1-2 and Fig.1-3). Strip
the machine again by the opposite actions.
Fig.1-1: Insert the screw into
the groove
Tip:
If the fastening block is too tight or to loose to lock the handle, please adjust
the fitting screw to be looser or tighter by hand.
STEP 2: Stick the sanding paper to the pad (See Fig.2). The holes on the sanding paper and
the holes on the pad must be congruent.
STEP 3 - Medium length installation: Loose the screw nut (Fig. 3-1) by anti-clockwise tur-
ning and extend the length. Then fasten the screw nut by clockwise turning (Fig.3-2). Go back
to the non-extended status by opposite actions.
The longest length installation: Insert the additional handle to the end of the machine. And
then turn the screw nut on the end of the machine for tightening. (Fig.4).
Fig.3-1
24
Heruntergeladen von manualslib.de
Risk of injury from unintentional switching on!
Before working at the maschine, unplug the network.
Fig.1-2: Lock on by fastening
block
Fig.2
Fig.3-2
Handbücher-Suchmachiene
www.schuller.eu
Fig.1-3: Finish installation
Fig.4