Important Warnings; Technical Specifications - Joyello JL- 968 SUPERPAPPA Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
Unscrew the container from the blade housing.
Important: Take the maximum amount of care during this activity. We recommend handling (and cleaning, where necessary) the cutting
blades with the maximum amount of care.
Place the food you wish to chop/homogenize inside the container and screw in the top support which contains the blade.
Screw in the container well and place it, along with the screwed in blade housing, above the chopper's compartment. Line up the 3 small plastic parts
that are sticking out with the 3 small operation buttons.
Press right the way down with your hand (without using excessive force) and the appliance will start chopping/ homogenizing the food using the
blades.
Check when the food is sufficiently chopped/ homogenized, and to stop the appliance, all you have to do is let go with your hand (so that you are no
longer pressing down on it with your hand).
Important: the food is chopped/homogenized in a time which ranges from circa 10 to 30 seconds. Therefore, once this process is finished, take the
plug out of the socket. Take the food out of the container and rinse it clean.

IMPORTANT WARNINGS:

Once you have finished chopping the food, shake the container with the food before opening it and pouring its contents.
Check that the food is at the right temperature before feeding your child.
If the temperature of the food is too low you can still use the appliance to heat it up (we recommend always keeping food at a temperature between
32° and 42°).
We recommend avoiding warming up food that has already been warmed up before.
be careful not to over-heat the food.
Only use the appliance for the uses described in this manual.
The appliance is for private/domestic use only (not professional use).
MAINTENANCE
Do not open or try to repair the appliance. Doing this means invalidating the warranty. Always contact an authorised assistance centre.
We recommend not using the appliance in places where the temperature is too high.
Always use clean (or filtered) water. This reduces the formation of limestone.
Always take the plug out of the socket when cleaning the appliance.
In order to clean the appliance and its parts, use a damp cloth. Do not use abrasive products or products that contain chemicals which are not
indicated.
Pour a solution of circa 100ml of cold water and 50ml of vinegar with cold water directly into the appliance and/or its accessories, and let it rest for
a few minutes, or in any case for the time necessary to remove the residues. Do not use or switch on the appliance while doing this. Then remove
the liquid from the appliance and/or its accessories and dry everything using a damp cloth. We recommend cleaning the appliance and accessories
in this way about every 4 weeks.

TECHNICAL SPECIFICATIONS

Power: 300 + 200 W
Power supply: 220-240V ~ 50Hz
Operation use conditions:Room temperature:
from 10°C to 40°C. Relative humidity: from 30% to 75% without condensation. Pressure: from 700 – 1060 hPa.
Environmental transportation and storage conditions:
Temperature: from 10 to 40°C. Humidity: from 5 to 95%. Pressure: from 700 – 1060 hPa.
This item is made in conformity with all the applicable European directives
DISPOSAL
The device (including its removable parts and accessories) must not be disposed of together with municipal waste at the end of its life, but
in compliance with European Directive. Since it must be handled separately from household waste, either carry it to a separately collected
waste disposal centre for electrical and electronic appliances or give it back to the retailer on purchasing a new device with the same
purpose. Any infringement will be severely prosecuted.
Specifications and designs are based on the latest information available at the time of printing and subject to change without notice.
9

Publicité

Table des Matières
loading

Table des Matières