Inspection And Maintenance - Toolland WHW250 Mode D'emploi

4. Attach the line to the load. For this purpose, carefully follow the
instructions of the line/hook manufacturer.
5. Place a heavy blanket or rug (not incl.) over the line.
Warning! Keep all bystanders away from the winch, the line, and the
load.
6. Push the pawl [2] up so that it engages with the gear.
7. Turn the handle clockwise to reel in the load.
When winding the line on the drum, pack the coils tightly side by side,
so that the next layers cannot slip between the coils.
8. When the load is reeled in, secure it.
9. When the load is secured, push the pawl down and turn the handle
counter-clockwise to release the strain on the line.
10. Remove the blanket or rug, and detach the line from the load.
11. Turn the handle clockwise to wind the line on the drum, and attach the
hook to the shaft.

9. Inspection and Maintenance

Only perform the maintenance as described in this manual. Any
other repair or maintenance must be performed by a qualified
service person using only identical replacement parts. This ensures
that the safety of the device is maintained.
Before Each Use
Salts, chemicals, and rust can affect components. Before each use, inspect
the general condition of the winch and line. Check for the following aspects:
 All hardware is tightly fixed.
 Moving parts are properly aligned and free to move.
 Parts are not broken or cracked.
 The line is not frayed, kinked, or damaged in any other way.
 Check for any other condition that may affect safe operation.
After Each Use
After use, wipe the external surfaces of the winch clean with a cloth.
Periodical Maintenance
Periodically, lubricate the steel cable with a light oil.
Lubricate the gear with gear grease.
V. 02 – 11/05/2017
WHW250
11 ©Velleman nv