Schwaiger NWSW5 Mode D'emploi Et Consignes De Sécurité page 14

USER GUIDE
9. INSTALLATION AND
CONNECTION OF THE SWITCH
Please read the following paragraphs and execute
the steps in the indicated order to avoid improper
installation.
• Please place the network switch over a stable
place or desktop.
• Never open the casing of the network switch even
in the event of power failure.
• The network switch may only be operated with
the included power supply and must be connected
to the correct voltage range that matches the
mains voltage indicated in the feature label of the
network switch.
• Please ensure that there is good air circulation
around the network switch.
Switch Connection
The network switch is powered by the external power
supply.
Plug-in power supply: Connect the hollow plug of the
supplied plug-in power supply to the DC IN socket on
the side of the network switch.
Connect the power supply to a power outlet. Check if
the power indicator lights up. When power is on, the
power supply is guaranteed.
The power supply can only be connected to a mains
voltage of 100-240 V, 50-60 Hz. The power supply
must always be within reach and be easily accessible
in order to disconnect the device from the mains. The
14