Alesis AcousticLink Guide D'utilisation Rapide page 10

WINDOWS SETUP
Once Cubase LE 5 is installed and activated,
follow the steps below to configure the software
to record with the AcousticLink.
1. Open Cubase LE 5. If prompted to open a
project, cancel for now.
2. From the menus select Devices
Setup.
3. In Device Setup click on VST Audio System.
4. In the ASIO driver dropdown box, select
ASIO4ALL. When asked to switch the driver,
select 'Yes'. Then select ASIO4ALL from the
left panel and click on the Control Panel
button at the top right of the window.
5. Click on the image of the wrench in the
bottom right corner and ensure that USB PnP
Sound Device is selected for the
input device and your internal
soundcard is selected as the output
device. Uncheck any other devices
listed here.
6. Click OK for the two windows that
are open, and then close and reopen
Cubase for the changes to take
effect.
7. In Cubase, click on File New
Project and select Empty, and
choose where you would like to save
your project.
Device
10