Parts List - Triton SJA470 Instructions D'utilisation Et Consignes De Sécurité

Thank you for purchasing this Triton tool. Please read this manual: it contains information necessary for safe
and effective use of this tool, and will enable you to get the full benefit of the tool's unique design. Keep this
manual close at hand and ensure all users of this tool have read and fully understand the instructions.
CONTENTS
Symbols
Warranty

Parts List

Assembly
SYMBOLS
Always wear ear, eye and respiratory
protection.
WARRANTY
To register your guarantee visit our web site at
www.tritontools.com* and enter your details.
Your details will be included on our mailing list
(unless indicated otherwise) for information on
future releases. Details provided will not
be made available to any third party.
GB
PURCHASE RECORD
Date of Purchase: ___ / ___ / ____
Model: SJA470
Retain your receipt as proof of purchase
Contents / Symbols / Warranty
2
2
2
3
3
Instruction warning.
Do not use before viewing
and fully understanding the
operating instructions
Triton Precision Power Tools guarantees to
the purchaser of this product that if any part
proves to be defective due to faulty materials
or workmanship within 12 MONTHS from the
date of original purchase, Triton will repair, or
at its discretion replace, the faulty part free of
charge.
This guarantee does not apply to commercial
use nor does it extend to normal wear and
tear or damage as a result of accident, abuse
or misuse.
* Register online within 30 days.
Terms & conditions apply.
This does not affect your statutory rights
PARTS LIST
1. Front Jaw (1)
2. Rear Jaw (1)
3. Coach Bolts (4)
4. Mounting Knobs (4)
ASSEMBLY
REMOVING THE URETHANE JAW FACINGS
Step 1
Remove the fixed jaw facing: use a
screwdriver or similar to pry the facing off the
fixed jaw.
Step 2
Remove the moving jaw facing: Push the
backing face to the right (when viewed from
the front of the Superjaws) to disengage the
connection pins. You can then remove first the
backing face and then the font face.
FITTING THE ENGINEERS JAWS
See Diagram, page 3
Step 1
Position the Front Jaw (1) onto the fixed jaw
so that the flanged edge is located on top of
the fixed jaw.
Step 2
Thread the Coach Bolts (3) through the aligned
fixing holes in the Engineers Jaws and the
fixed jaw, so that the bolt heads locate in the
fixing positions in the front of the Engineers
jaws.
Step 3
Fit the Mounting Knobs (4) onto the bolts and
tighten to secure the Front Jaw (1) in position.
Step 4
Position the Rear Jaw (2) onto the moving jaw
so that the flanges locate over the top and
bottom of the moving jaw
Step 5
Secure the Rear Jaw (2) using the remaining
Coach Bolts (3) and Mounting Knobs (4)
Parts List / Assembly
GB
3