Safety Switch; Cleaning; Troubleshooting - SilverCrest SKE 1500 A1 Mode D'emploi

RP90979 elektrischer Kamin LB3 Seite 8 Dienstag, 9. Juli 2013 4:48 16

6.3 Safety switch

A safety switch protects the appliance from
damage caused by toppling over or shocks.
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before
each clean;
– allow the appliance to cool
down;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
1. Carefully remove major dust deposits
from the protective guards with a
vacuum cleaner.
Fault
Appliance cannot be Faulty fuse or wall socket
switched on
Faulty appliance
Appliance switches off Safety switch has triggered
automatically
Thermal cut-out has triggered
8
The safety switch is located inside the
appliance and switches it off immediately if
it falls over or is subject to a major shock:
• Return the appliance to a stable, upright
position.

7. Cleaning

2. Remove any remaining dirt with a soft
brush.
3. Clean the outside of the appliance with
a damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
4. Wipe the appliance with a cloth
moistened with clear water.
5. Do not use the appliance again until it
has dried completely.

8. Troubleshooting

Cause
Select another wall socket
Have repairs carried out at a specialist
workshop or dispose of the appliance. You
will find the service address in "Service
Centre" on page 10.
Set the appliance upright (see "6.3 Safety
switch" on page 8)
Allow the appliance to cool down (see
"6.2 Thermal cut-out" on page 7)
Clean the appliance (see "7. Cleaning" on
page 8)
Remedy