Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Unpacking
Delivery Inspection
After removing the carton, carefully inspect the power
management system components for any damage that may
have occurred during shipment.
IMPORTANT: If loss or damage is noted at time of
delivery, have the person(s) making delivery note all damage
on the freight bill and affix his signature under the
consignor's memo of loss or damage. If loss or damage is
noted after delivery, contact the carrier for claim
procedures. Missing or damaged parts are not warranted.
Shipment Contents
• Power Management System
• Installation and Operator's Manual
• Wire Connectors (4)
• 1/4" Double Male, Single Female Lugs (2)
Figure 1 — A Typical Power Management System Mounting
Hot
Water
Heater
Branch Circuits
INSTALLATION
Contactor
Main
Breaker
Panel
Mounting Guidelines
The power management system is enclosed in a NEMA
Type 3R enclosure suitable for indoor/outdoor use.
Guidelines for mounting the power management system
include:
• Install power management system on a firm, sturdy
supporting structure.
• The power management system must be installed with
minimum NEMA 3R hardware for conduit connections.
• Level and plumb the enclosure.This can be done by
placing washers between the power management system
enclosure and the mounting surface.
• NEVER install the power management system where any
corrosive substance might drip onto the enclosure.
• Protect the power management system at all times
against excessive moisture, dust, dirt, lint, construction
grit and corrosive vapors.
A typical installation of the power management system is
depicted in Figure 1. It is best if it is mounted near the main
breaker panel, either inside or outside. Discuss layout
suggestions/changes with the owner before beginning the
system installation process.
Service Disconnect
Transfer
Switch
Power
Management
System
Disconnect Switch
6
Watt -
Hourmeter
Generator
Air
Conditioner
Publicité
Chapitres
Table des Matières
Dépannage
