Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USING THE VHF-10&20 - HANDMIC VERSION
1 / Remove the packing material, and keep it.
2 / Plug the power supply adaptor into the power supply connector on the back side
of the receiver.
3 / Connect the audio connector.
Note: For the dual receiver RV-20, you can use the XLR balanced audio output
(one per channel), or the mix TRS output (unbalanced output)
For the single receiver RV-10, you can choose the audio output level (LINE or
MIC).
4 / Fully extend the antenna.
5 / Open the handmic battery cover and insert the battery.
6 / Turn on the receiver. The power indicator will light up.
7 / Turn on the handmic, if the LOW BAT. indicator is always lighted, your battery is
defective.
8 / As soon as handmic is turned on, RF indicator on receiver must light up.
9 / Adjust the volume on the receiver, you are now ready to use your microphone
wireless system.
USING THE VHF-10&20 - HL VERSION
1 / Remove the packing material, and keep it.
2 / Plug the power supply adaptor into the power supply connector on the back side
of the receiver.
3 / Connect the audio connector.
Note: For the dual receiver RV-20, you can use the XLR balanced audio output
(one per channel), or the mix TRS output (unbalanced output)
For the single receiver RV-10, you can choose the audio output level (LINE or
MIC).
4 / Fully extend the antenna.
5 / Open belt pack battery cover and insert the battery.
6 / Connect the headset (or Lavalier mic) cable to the belt pack.
7 / Turn on the receiver. The power indicator will light up.
8 / Turn on the transmitter, if the light is always lighted, your battery is defective.
9 / As soon as handmic is turned on, RF indicator on receiver must light up.
10 / Adjust the volume on the receiver and on the transmitter. You are now ready to
use your microphone wireless system.
Publicité
Table des Matières
