Technical Data - ProfiCare PC-HR 3023 Mode D'emploi

WARNING:
• Before cleaning the handset with water, disconnect it from the
connection cable.
• Disconnect the power adapter from the wall socket when
cleaning.
• Do not immerse the appliance and the power adapter into water.
CAUTION:
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
Shaving Head
Cleaning after each Use
You may clean the shaving head under running water.
1. Switch off the appliance.
2. Press the unlock button for the shaving head. Remove
the shaving head.
3. Rinse the shaving head under hot running water. Clean
the shaving head in soapy water once in a while.
NOTE:
Do not clean the appliance with water of over 60 °C.
4. Rinse thoroughly with clear water afterwards.
5. Let the cleaned parts dry.
6. Place the shaving head back onto the handpiece. It must
audibly snap.
Alternatively, you may clean the shaving head with the
brush provided.
CAUTION:
The shaving foils must not be cleaned with the brush!
Monthly cleaning
Thoroughly clean the shaving head once a month. If neces­
sary, use special cleaning aids available in specialist shops.
1. Switch off the appliance.
2. Press the unlock button for the shaving head. Remove
the shaving head.
3.
WARNING: Risk of injuries!
The shear blades are sharp!
Disassemble the shaving head. Please refer to the over­
view on page 3. Proceed as follows:
3.1. Unscrew the unlocking of the shaving foil fixer in the
direction of the arrow.
3.2. Remove the shaving foil fixer by pulling it up.
3.3. Remove the shaving foils and shear blades.
PC-HR3023_IM
Cleaning
4. Rinse all parts of the shaving head under hot running
water. Occasionally clean these parts in a soap solution.
5. Rinse thoroughly with clear water afterwards.
6. Let the cleaned parts dry.
7. Put the shaving head back together in reverse order.
8. Lubricate the shaving foils using light machine oil (a few
drops are sufficient).
Cleaning the Hand-held Unit and Power Adapter
• You may wipe these parts with a damp cloth.
• Use slightly soapy water to remove spots.
Changing the Shaving Head
To maintain the shaving performance at 100 %, replace the
shaving head at the latest every 18 months or when the
shear parts show wear.
For replacement parts, please consult your dealer.
Model:................................................................. PC-HR 3023
Net weight: ........................................................ approx. 168 g
Protection class: ..................................................................
Input: ............................................................DC 5 V, 1000 mA
Degree of protection against liquids: ............................ IPX5 *
Power Adapter
Protection class: ...................................................................
Input: .................................... AC 100 - 240 V, 50 / 60 Hz, 0.2 A
Output:..........................................................DC 5 V, 1000 mA
Rechargeable battery: ...................1 x 3.7 V, 800 mAh Li-Ion
Run time: ...................................................... max. 60 minutes
Charging time: ...............................................................1 hour
* This appliance complies with IPX5. This means the appli­
ance is protected against regular jet water.
The right to make technical and design modifications in
the course of continuous product development remains
reserved.
This appliance has been tested according to all relevant
current CE guidelines, such as electromagnetic compatibil­
ity and low voltage directives, and has been constructed in
accordance with the latest regulations.

Technical Data

13.04.18
39