Changing The Units Of Measure - Dymo S50 Guide D'utilisation

Pèse colis usb numérique portable
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
3. Place the items to be weighed in the container.
The display shows the weight of the items, without the weight of the container.
4. After removing the container, press
Using the Hold Feature
When an item being weighed extends over the front of the scale and you cannot see the
display, you can freeze the display so that the weight is still displayed after removing the item.
To use the Hold feature
1. Press
.
HOLD
The display shows HOLD and then 0.0 when ready.
2. Place the item on the scale.
3. After a few seconds, remove the item from the scale.
The weight continues to be displayed for about ten seconds.
4. Press
to deactivate the hold feature.
HOLD

Changing the Units of Measure

Your scale can display weight in English (pounds) or metric (kilograms) units. The default unit
of measure is metric. Each time you turn on the scale, the scale defaults to the unit of measure
that was last used.
To change the units of measure
Press
to toggle between English and metric units.
Mounting the Display
The scale features a detachable display. The display can be mounted to most metallic surfaces
using the built-in magnets. You can also mount the display using the mounting holes on the
back of the display and standard screws. A mounting template is included at the back of this
User Guide. The display can be mounted up to 1.8 meters (6 feet) from the scale base.
To mount the display to a non-metallic surface
1. Drill two holes 120 mm (4 3/4 inch) apart at the desired height on the wall using the
template at the back of this User Guide.
2. Screw one screw into each of the holes until the screw head sticks out from the
wall 3 mm (1/8 inch).
!
Allowing the screw heads to stick out farther than 3 mm (1/8 inch) may damage the
scale display.
3. Align the holes on the back of the scale display with the screws.
4. Slide the display onto the screws.
The display should slide onto the screws firmly and securely.
4
to reset the scale to zero.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

S100S180

Table des Matières